Audi A3 S-Line & S3 Sedan Front Splitter — 8Y Facelift 2024+ Gloss Black

Sharpen the front end of your facelifted A3. This front splitter is shaped for the 2024 facelift front bumper of the Audi A3 S-Line and S3 Sedan (8Y), extending the lower edge for a lower, wider stance while protecting the bumper from scuffs and kerb damage. Moulded from UV-stable ABS in a deep gloss black finish, it follows the bumper's original contour for a clean, factory-look fit.

Fits

• Audi A3 S-Line Sedan 8Y Facelift (2024+)
• Audi S3 Sedan 8Y Facelift (2024+)

Not compatible with

• A3 / S3 Sportback (hatchback)
• A3 / S3 8Y pre-facelift (2020–2024)
• Audi RS3 8Y
• Standard (non S-Line) A3

⚠ Compatibility note: Shaped for the facelift S-Line / S3 Sedan bumper. Please compare your bumper with the listing photos before ordering.

What's in the box

• 1× Front Splitter — Gloss Black ABS
• Stainless steel screw mounting kit
• Fitting manual

Key features

• Fits A3 S-Line and S3 — one splitter for both facelift sedans
• Vehicle-matched fit — moulded for the 2024 facelift bumper, gap-free along the full edge
• Screw-fit — mounting holes are drilled into the bumper at the marked points; kit and manual included
• UV-stable ABS — resists fading, warping and road debris
• Paintable — can be colour-matched by any body shop

Installation

The splitter mounts to the lower edge of the front bumper using the supplied screw kit. Mounting holes are drilled into the bumper at the marked points — no cutting or trimming of the bumper is needed.

1. Dry-fit the splitter and check alignment along the full bumper edge.
2. Mark the mounting points using the splitter as a guide.
3. Drill the marked points and secure with the supplied screws, working from the centre outwards.

Basic hand tools and a drill are needed (approx. 45–60 min). Professional installation is recommended if unsure.

FAQ

Does it fit the pre-facelift A3 8Y (2020–2024)?
No. The 2024 facelift has a new front bumper; this splitter is for facelift cars only.

Does it fit the A3 Sportback?
This splitter is listed for the Sedan. Compare your bumper with the photos before ordering.

Is drilling required?
Yes. The splitter is screw-fitted: holes are drilled into the bumper at the marked points using the supplied kit.

Is it road legal in the UK?
Yes, when securely fitted and not obstructing lights or the number plate. Tell your insurer about any modification.

Complete the look

Pair it with the AeroFinityWorks A3 S-Line 8Y Facelift rear valance for a complete styling package.